ISDN4Linux: Dynalink

ISN network and Linux, how?

Thu Mar 10 19:41:07 CET 2005
Copied from http://www.wurtel.cistron.nl/cards/dynalink.html

Dynalink IS64PH / Asuscom ISDNLink

There are two versions of this card, an old one:

and a new one:

Both work (choose "asuscom" as type, i.e. type=12 . You must also give the irq and io parameters (from the isapnp setup).

Configuration:
IS64PH type=12 protocol=2 irq=X io=0xXXX io and irq according to isapnp config


Dynalink PCI / Asuscom ISDNLink PCI

There is support for this card since September 1999. See the Dynalink page for more info. The first Dynalink PCI cards used the winbond chip, i.e. type=36. You do need at least kernel 2.2.13 for this! (or use the driver available from the Dynalink page).

There are also Dynalink / Asuscom PCI cards that are based on the HFC 2BDS0 PCI chip; there is a separate page for that. Hence, it is important to first look at the name on the chip before installing it! HFC is type=35, Winbond is type=36.


© 2000 Paul Slootman
May be used, copied and distributed freely, but my name, this copyright text, and the URL http://www.wurtel.cistron.nl/cards/dynalink.html must be kept intact. See it as a sort of GPL. Exception: Teles may only use this after express written or PGP/GPG signed permission.
Please send any changes and/or additions to me directly so that I can integrate them into my original document (if they are worthy).